Coolant in Indian Summers: What Your Car Needs in Extreme Heat

You probably know that feeling. Stuck in city traffic on a hot May afternoon, the sun is relentless, and the temperature is touching 44°C. You glance at the dashboard and notice the gauge rising. The AC is on full blast. The engine is working hard. Your car is sweating too, even if you can’t see […]

Read More +

Is Your Thermic Fluid the Reason Your Boiler Fuel Bills Keep Rising

A heater running on degraded thermic fluid does not break down or trigger alarms. It just consumes more fuel than it should, gradually, every single day. The fluid thickens, oxidises, and leaves carbon deposits on the coils that restrict heat transfer and force the burner to compensate. The signs are easy to miss, and most […]

Read More +

Is Poor Oil Quality Causing Your Air Compressor to Overheat

An air compressor rarely shows signs of trouble at first, but it almost always follows a pattern. They build up over weeks: a few degrees warmer, a slightly longer cool-down, until the thermal protection kicks in and the machine stops. The filter, the fan, and the room temperature need a check. Oil condition, however, is […]

Read More +

Why Is Your Refrigeration Oil Turning to Gel Inside the Evaporator

It’s peak summer. Your cold storage is running. The compressor sounds fine. Yet temperatures inside just won’t drop. A technician opens the system and finds a thick, gel-like coating inside the evaporator coils. Not ice. Not refrigerant. Oil. Sitting there, congealed and going nowhere. This happens in ice plants and cold storage units more often […]

Read More +

Why Your Hydraulic Pressure Drops When the Temperature Rises

Pressure loss in a hydraulic system sends everyone looking in the same direction: a worn part, a broken seal, or something that needs replacing. And that makes sense, because those are things you can actually get your hands on and test. Operators go through everything carefully, sometimes replace parts that look suspect, and the problem […]

Read More +

Gear Oil
March 4, 2026
By adminignite
Comments 0

Saving Your Gearbox from Eating Itself: A Guide to Micro-Pitting

Micro-pitting is one of the most common reasons gearboxes fail way before they should, and the frustrating part is you almost never see it coming. By the time something feels wrong, the damage has already been quietly building for weeks. A lot of the time, the oil is the problem. The wrong gear oil, or […]

Read More +

oil and grease
February 23, 2026
By adminignite
Comments 0

Metal on Metal: Why Standard Grease Fails Under Shock Loads

Failure in heavy industry does not tend to announce itself politely. It starts with a slight metallic hammering, a vibration, which seems a bit out of place, or a bearing, which is quite a bit warmer than normal. Then one day, it is metal against metal. Shock loads are brutal. Unlike steady loads, they act […]

Read More +

oil and grease
February 16, 2026
By adminignite
Comments 0

The “Cheap” Oil Trap: Calculating the Real Cost of Machine Downtime

Your plant manager is woken in the middle of the night by a sudden call. A critical line has stopped. The purchase order, which saved a few rupees per litre, no longer even seems like an intelligent move. Result? A sudden genesis of the cheap oil trap. It will not be with a melodramatic bang, […]

Read More +

oil and grease
February 9, 2026
By adminignite
Comments 0

One Bad Batch of DEF Will Kill Your Sensors: Here is How to Spot It

A scene most fleet managers are familiar with is a good place to begin. The truck, which was fine yesterday, suddenly started giving an SCR warning light today. Suddenly, you perceive errors on the dashboard. The car enters limp mode. The service staff accuses the sensors. The accountant is preparing to encounter yet another unexpected […]

Read More +

oil and grease
February 2, 2026
By adminignite
Comments 0

Why Water in the Radiator Eats Holes in Your Engine Liner (Cavitation)

Liner cavitation is not a theory or a law. When water leaks in, you must be losing your head in a big way as a fleet manager of some kind of truck, genset, tippers or heavy equipment. Unlike the holes in your teeth caused by your incessant habit of eating sweets, the water in the […]

Read More +

Year: 2026

Coolant in Indian Summers: What Your Car Needs in Extreme Heat

Is Your Thermic Fluid the Reason Your Boiler Fuel Bills Keep Rising

Is Poor Oil Quality Causing Your Air Compressor to Overheat

Why Is Your Refrigeration Oil Turning to Gel Inside the Evaporator

Why Your Hydraulic Pressure Drops When the Temperature Rises

Saving Your Gearbox from Eating Itself: A Guide to Micro-Pitting

Metal on Metal: Why Standard Grease Fails Under Shock Loads

The “Cheap” Oil Trap: Calculating the Real Cost of Machine Downtime

One Bad Batch of DEF Will Kill Your Sensors: Here is How to Spot It

Why Water in the Radiator Eats Holes in Your Engine Liner (Cavitation)

What Makes Calcium Sulphonate Grease Ideal for Marine Applications

Does Calcium Sulphonate Grease Work for Open Gears, Kilns and Casting

How Is Lithium Complex Grease Different From Standard Lithium Grease

Operating Hours

Quick Links

Category

Official info

Archives

Categories